![glock ejector replacement glock ejector replacement](https://i.ebayimg.com/images/i/223179267760-0-1/s-l1000.jpg)
I would probably not replace any internal parts unless the gun doesn’t run. Sometimes, I confess wanting a longer grip. What more could I possibly want from a gun? This gun has killed every critter I’ve shot it at, hit every target, runs and runs like anything using quality ammo, and acceptably well on the cheapest crap imaginable. I plan to get a gen 5 at some point, but really I’m not in a hurry. It is one of my favorite guns of all time. One $18 new RSA later, and it was back online. The *only* issues I’ve ever had with it were several Russian steel case rounds that didn’t want to pop, one aluminum case from an Independence round (noticeably weak ejection - I stopped and checked the barrel for an obstruction) that flipped over and landed in the ejection port, and after about 2500 rounds, a chunk of the RSA nose cap disappeared. At ~325 rounds, I put a set of Trijicon HDs on it and kept shooting it. I cleaned it, lubed it, put an SCD on it, and started shooting it. I bought a used G26.3 several years ago, my first Glock. I want to order all these before the waiting period of the gun. I want to buy one that is slightly longer to put a little more pressure if needed. I just put the gen4 ejector into the new gen3 trigger block I buy and put into the gun.Īlso, I don't know where to buy the extractor spring load bearing. I am going to play it safe and put away the origin trigger block with the ejector untouched so if all else gone wrong, I just put back the original assembly.
![glock ejector replacement glock ejector replacement](https://i.ebayimg.com/images/g/1OoAAOSwWkRdFD2H/s-l400.jpg)
I plan to buy a new gen3 trigger block and a gen4 trigger block( to take the ejector out). I went on the Glock Store, looked like the gen4 ejector(30274) can just fit into the gen3 trigger block. I was to experiment changing some parts, here are my questions.ġ) Is the stock MIM extractor really bad that it won't last? Or is it just Apex trashing the MIM Glock extractor to sell their expensive extractor?Ģ) I want to change the ejector to gen4 as I read and watch on line that gen 4 is better. I think I may just look into getting the extractor and seeing about rebuilding it myself.I just bought a new Glock 26 gen3 today, I will have it in 10 days. It seemed to sling everything from 147 golden sabers to 115 tulammo to winchester white box all over the place for me though. From what I've read, I've got the 336 extractor or whatever (gun isn't with me at this moment) and it has been known to have issues with 115 grain ammo. Apparently the gun shop wnated to get rid of them. The gun ,contrary to the post, was not used. Perhaps I shall get the Lone Wolf extractor. But it's definitely slinging brass in my face no matter how well it's gripped. maybe that one time, I wasn't as "on it" as I thought. I had dropped hte mag to see how many bullets I had left, and there was jsut the one in the champer, so I shot it one handed and it stove piped. The stovepipe that one time was with no magazine in the gun. My sister in law stove piped my Springfield a couple of times. I never have stovepipe issues, I know what you mean by the limp wristing thing too. I've been shooting pistols for about a year, I've done basic and tactical trianing.